Friday, 18 January 2013

How to Fix 0x8004210a Error in Outlook 2010

Are you getting 0x8004210a Error on Outlook 2010? this is one of the most annoying errors that is often experienced by the Outlook 2010 users. The error is often faced when the users tries to access the data stored as PST files. The users face problems while sending or receiving mails using POP 3 email account. It is also referred as time out error as the users simply fail to access the contents of the mails. The attachments along with the emails gets inaccessible resulting in loss of data. It can also have an adverse impact of the PST files and thus makes it inaccessible for further uses. The above error can also be caused when the server cannot be found or unable to be located. Thus, the users are advised to check the Internet connection and secure it properly.

If the problem still exists, then it is a clear indication that the PST files have been damaged and the users have to configure the account settings once again. It can be difficult for the newbie Outlook users, thus it is better to switch to third party Outlook PST repair software that is competent enough to overcome and fix 0x8004210a 2010 Error easily. It is enabled with advanced scanning algorithm to fix even the severely corrupted PST files or any other issues resulting in the damage of Outlook 2010 or its earlier versions.

 


 User Guide: How To Use the Software in Outlook 2010

 


Step 1 Once Downloaded, install the Software 

 

Step 2: When the installation is complete, launch the program



 


Step 3 Press Next and follow the instruction to start scanning




Step 4 After scanning is over preview of the recoverable components is displayed.

Step 5 Get the Licensed Key of the software and save the repaired PST files


       

No comments:

Post a Comment